How do I program a Macro on the RC2000?

Posted by Nigel Pond [SysOp] [IP: 152.167.204.4] on December 29, 1998 at 09:50:24:

In Reply to: How do I program a Macro on the RC2000? posted by Bailey on December 27, 1998 at 22:23:15:

Bailey

I only have the manual for the Mark II to hand, but I think the procedure is the same:

1. Using a suitable implement, press the recessed MACRO button. MACRO should appear in the LCD display and "learn" should flash;

2. Press the macro button you wish to program - eg button 1 - now M1-00 should appear in the display indicating that you are programming button 1 and the number of steps recorded so far, which is 00;

3. Then key in the sequence of commands that you want the macro to execute. The 00 number should increase with each command and a timing indicator will also show, indicating the timing between steps - default is 0.5 sec I think;

4. When finished, depress the recessed macro button again;

5. Test the meacro by pressing the programmed button - 1 in the above case and then the PLAY key.

That should do it. If you would like a copy of the manual, the one for my mark I should be around somewhere, so I could photocopy it for you.

Follow Ups:

• How do I program a Macro on the RC2000? - Dennis Pagoulatos 17:22:30 12/29/98 (1)
  • How do I program a Macro on the RC2000? - Nigel Pond [SysOp] 17:31:55 12/29/98 (0)

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive