Ground loop hum

Posted by Alan Maier[SysOp] on September 27, 1998 at 08:52:34:

In Reply to: Ground loop hum posted by mikem on September 26, 1998 at 21:03:51:

Mike,

The problem in your setup is that the two circuits have a problem with ground potential. Most likely the existing circuit had a faulty ground due to a weak point in the chain of outlets - you might want to address this for piece of mind as it indicates a possible house wiring problem, in particular you most likely have a bad ground connection at an outlet between your system and the service panel. In the meantime you need to connect your entire system to the dedicated line.

Alan

: I had my stereo setup running off of one 14ga 15amp circut. I decided to add a dedicated AC 20amp 12ga wire circut for my amps. When I did this I now get a hum from my speakers. When I plug everything into the old circut the hum disappears.
: So I know its being caused by the new ground. Any tips for correcting this?
: I put a cheater plug on the new circut bypassing the ground and all is fine. I would like to fix this the correct way.
: My next step is to go into the breaker panel and wire the grounds and neutral wires together. They are currently on common blocks. Do you think this would help? I appear to have a mis-match of resistance which is causing the hum.
: Another thought is to run the ground wire from the new socket to the old one, thus passing the ground back to the old circut from the new one. This would keep a common ground and maybe kill the hum?
: Any adive or comments?

Follow Ups:

• Ground loop hum wt kwong 23:30:58 10/02/98 (0)

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive