Speakers Buzz with Yamaha RX-V2095 and Carver Amps

Posted by Alan L. Maier [SysOp] [IP: 129.37.205.149] on January 31, 1999 at 21:08:35:

In Reply to: Speakers Buzz with Yamaha RX-V2095 and Carver Amps posted by Gary Love on January 31, 1999 at 17:30:44:

Gary,

Do you have the Carver on the same electrical outlet as the Yamaha? Also do you have a television set or VCR with connections to a cable television system? I suspect a ground problem having to do with spreading out the electrical connections or a cable feed ground vs. system ground problem.

Try connecting the Carver to the same outlet as the Yamaha, and disconnect the cable televison feed (or the television set if it is connected) and try it.

Alan

: I just installed a new Yamaha RX-V2095 in my system. I am using the pre-amp outs. I am using 3 Carver TFM-55X THX rated amps. I am getting a very faint buzzing sound out of all the speakers. Receiver volume adjustments have no affect on the volume of the buzzing sound. My power cables and audio/video cables do not get near each other. If I disconnect the pre-amp outputs from the receiver to the amps the buzzing stops. I have disconnected all components going into the receiver and still have the buzzing. Any suggestions to stop the buzzing would be appreciated.

: Thanks

:

Follow Ups:

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive