B&W Matrix 3 tweeter replacement
Posted by Mike [IP: 12.78.146.181] on March 27, 1999 at 20:01:14
Using Mozilla/4.5 [en] (Win98; I):
In Reply to: B&W Matrix 3 tweeter replacement posted by Ken Simmons on March 27, 1999 at 12:12:52:
I recieved a response from B&W. this is it below.Dear Mike, It is possible to test the tweeter from the wires at the crossover board.
Replacement of the tweeter is done at the front baffle. On the front baffle, about an inch in from the top and sides of the
speaker, there is a small removable square made up of four of the baffle
"bumps" with a hole at the center large enough for a paper clip to be used
as a tool. Pull out the baffle squares to reveal fixing screws.
There are two more squares just a few inches below the upper ones that also
need to be removed along with the screws behind. Now, the tweeter baffle
can be taken from the cabinet. The leads are removed from the tweeter
(make note of the wire color connections to the tweeter). It may be possible to order a replacement tweeter diaphragm from our
Parts/Service Center (978) 664-2870. When it is time to replace the
tweeter or if these instructions are not very clear, I can be reached at
the same number for basic assistance. You may want to order the Service
Manual along with the tweeter diaphragm. Regards,
Tim - B & W
Follow Ups:
Return to the new SMR Forums Menu
Design
& HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without
permission. The images on this page are digitally watermarked. New forum
messages should be posted into SMR Forums v2 - http://www.smr-forums.com/
|
