Bi-wiring my speakers?

Posted by Matt [IP: 212.211.20.3] on December 01, 1998 at 21:42:21:

In Reply to: Bi-wiring my speakers? posted by Tom Borowski on November 24, 1998 at 13:52:53:

Tom,

I will probabaly get flamed but my advice is save your money. Everything that I have read says that you will not hear the difference in biwiring. Since the signal from the amp is the same into both wires! However bi-amping can make a difference for example if you had a tube amp for your high range and a transistor amp for the low range. I have Kef Ref 3's and they support bi-wiring but I have not done it. Just my two bits i hope this helps

: Hi, my speakers PSB Century 600i can be bi-wired. I run them on the Sony ES50 reciever which can be switched to 4ohms. Should I do it? Will I get better sound?

: Please advise....

Follow Ups:

• Bi-wiring my speakers? SMR [WizOp] 21:43:52 12/01/98 (0)

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive