Which one would be better to use for a sub?

Posted by Dan Ingler [IP: 208.202.230.70] on November 02, 1998 at 13:25:19:

In Reply to: Which one would be better to use for a sub? posted by Turner on October 30, 1998 at 21:13:57:

: I have an Onkyo 828THX receiver and a Velodyne powered subwoofer, on the back of the Onkyo there is a sub output and a sub preout. My question is: which one would be better to put the sub in, the output or preout and why? Another question, there is an internal crossover in the Onkyo and a crossover on the sub, which one would be better to use? Thanks in advance.

Can't say for sure but here is a good guess: I would use the sub out and not the pre out. (they may even be one in the same) The crossover built in to the Velodyne was designed with that driver and with that amp. Onkyo has no way of knowing what will be used on the preouts. I would try both and my bet is that you really can't tell any difference.

Dan Ingler

Follow Ups:

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive