 |
 |
 |
 |
|||
           |
Speaker-level vs Line-level sub connections??????
Posted by Simon Johnson [IP: 150.237.116.195] on August 23, 1999 at 06:30:58 In Reply to: Speaker-level vs Line-level sub connections?????? posted by Philip Brandes on August 23, 1999 at 03:36:01: IMHO, the speaker-level inputs might be the better choice. You are less likely to have problems with signal degradation with the high-level output than with a line-level output over a 50 ft. run, especially as you would need to pass the signal back to the amp from each sub. Of course, as Philip mentioned, you must make sure that the speaker-level output from each subwoofer to the sides (which I believe you will be using) is high-passed, to avoid damaging your surrounds. If you can't do this with the speaker-level inputs/outputs, you'll need to either use an external cross-over or use the line-level option, in which case some form of shielded cable might be necessary - there are almost certainly postings on this in the archive. Hope this is of some use. Simon
Follow Ups:
Forum 2 Archive 2 Sections:
Return to the new SMR Forums Menu
|
|
||||
|
 © SMR Group 2001-2004 - http://www.smr-group.co.uk/ |
|
||||
