12 Volt Trigger

Posted by Andrew Clark on September 30, 1998 at 17:04:00:

In Reply to: 12 Volt Trigger posted by Mel Robinson on September 30, 1998 at 15:11:53:

Niles makes an adapter called an FOS-512 that converts the 5-pin DIN connector to a 2 conductor bare wire. Or you can cut one end off a 5 pin DIN cable and utilize the leads from the outermost pins on the DIN connector which are numbered 1 & 3 (don't ask). I usually use a meter to check continuity. Anyway after you have the correct bare wires identified, connect the adapter cable from the output of the LDD-1 to the first amplifier. Don't worry about which wire you connect to which terminal (AC or DC on the amplifier), but make sure you are consistent from amplifier to amplifier. So if pin 1 is connected to DC on the first amplifier, make sure DC is connected to DC on the second and third amplifiers. AC to AC.

Follow Ups:

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive