12v triggering of my Adcom GFA-7500 amp?

Posted by Kris Young [IP: 209.109.233.190] on March 01, 1999 at 21:46:13
Using Mozilla/3.0C-NC320 (Win95; U):

In Reply to: 12v triggering of my Adcom GFA-7500 amp? posted by Lee Ross on February 28, 1999 at 01:53:27:

Lee,

I think there is a pinout of the din connector on the panamax page you were referring to. I believe pins 1&2 are ground and pin 3 is 12v. On a mini plug I think the tip should be 12v and the shaft is ground. I put my connector together for my panamax some time ago. I'm going from memory. If you follow the directions on the panamax page but connect to a mini plug instead of the female AC plug you should be ok.

din plug pin 1 or 2(GND) to shaft of mini-plug

din plug pin 3(12v) to tip of mini-plug

If you have a multimeter you can make sure which wire goes to the tip or base before soldering. Hope I don't screw you up. If you can solder it should take 5min.

Good luck,
Kris

Follow Ups:

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive