Bare Wire Trigger
Posted by Jerry Levy [IP: 12.79.18.60] on July 27, 1999 at 21:12:06
Using Mozilla/4.0 (compatible; MSIE 5.0; Windows 98; DigExt):
In Reply to: Bare Wire Trigger posted by Doug Wells on July 27, 1999 at 20:45:08:
Lex,
I dont have any experience with the trigger terminals on the mc-1 because I was used to the dc-1 setup (the din type connector). for that you just stick one connector in the #5 pin and the other in the #1 pin until you get remote switching (you might have to try each one in each slot). then take some electrical tape and tape over the cable to the mc-1 so it doesnt slip away. My thought about the screw on terminals is that maybe you should try reversing the wires because maybe you have the one for the trigger and the one for ground backwards (this happened to me first)- and remember to terminate the last amp by plugging in the mini plug to the amp with the other end just chillin out there in Lexspace! :)- jerry
Follow Ups:
Return to the new SMR Forums Menu
Design
& HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without
permission. The images on this page are digitally watermarked. New forum
messages should be posted into SMR Forums v2 - http://www.smr-forums.com/
|
