Bare Wire Trigger

Posted by Alan Barton [IP: 171.214.197.46] on July 28, 1999 at 00:06:07
Using Mozilla/4.03 [en] (Win95; U):

In Reply to: Bare Wire Trigger posted by Doug Wells on July 27, 1999 at 22:46:09:

I tried tightening the screw while looking in the hole where the wire is to be inserted. First when looking into the wire hole, it appeared to just be a simple hole and not very deep. It looks just like the picture in the manual. The wire didn't stick in the hole very far at all. It appeared that by tightening the screw down it caused something to raise from the floor of the hole and secure the wire. I didn't pay that close attention but I believe that is what I saw. I would go look again but I have my whole system assembled on the rack and I really can't get to it like I could yesterday. However, after tightening the screws the wire was secure.

I should also point out that I was not using a Proceed amp. I hope this helps.

Alan Barton

Follow Ups:

• Bare Wire Trigger - Doug Wells 09:14:44 07/28/99 (0)

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive