THX speakers with Lexicon?

Posted by Josh Carter [IP: 199.45.77.36] on August 24, 1999 at 11:32:20
Using Mozilla/4.51 [en]C-CCK-MCD cal-v4512 (WinNT; U):

In Reply to: THX speakers with Lexicon? posted by Doug Salvas on August 23, 1999 at 15:23:15:

Hi Doug, I promise I won't call you Lexman this time! ;-)

I have the M&K 150THX system. They also roll of the S-150 LCR's at 80Hz (and the surrounds at 100Hz). I have an MX-350THX for the LFE channel and will be getting two MX-105's for the side channels for BE (bass enhance). I will use the M&K HP-80-2 passive 80Hz high pass filter to remove the bass from the SS-150 side speakers. I will run the L/R MX-105's from the full range bypass L/R output signals of the filter and set the subs internal x-overs at 80Hz. This system creates a fourth order linkwitz-riley network with the sides and the subs so they will blend frequencies perfectly. I will just have to set volume on the subs to match the sides and I will be set! I will set the MC-1 x-overs as such. Mains-80Hz, center-120Hz, sides-large, rears-120Hz. This is about as perfect a BE set-up as you can get. However, none of this will be done until next year when I move out of dorms.

A similiar set-up should be attainable with the AT's. Unfortunately, I can offer no opinion on the AT's as nobody carries them here so I have never heard them. I can certainly recommend the M&K's though.

Hope this helps and good luck.

Josh

Follow Ups:

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive