Output level adjustment

Posted by Steve C. [IP: 12.77.54.26] on August 28, 1999 at 07:55:05
Using Mozilla/4.0 (compatible; MSIE 4.01; Windows NT):

After finally getting my front projection system perfectly dialed in (including ISF calibration), it's time to fine tune my sound. I'm sure this has been covered in the past, but am I better off using the MC-1's internal test signals, or should I use the test sounds from my LD and DVD versions of Video Essentials?

I have the the input voltage level on my amps set to the THX reference level and am ready to fire up my trusty Radio Shack SPL meter. Any opinions out there?

Follow Ups:

• Output level adjustment - Philip Brandes 10:39:36 08/28/99 (0)

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive