HELP! 8ohm receiver driving 4ohm M&K speakers?

Posted by Alexander [IP: 141.51.188.90] on January 07, 1999 at 12:45:13:

In Reply to: HELP! 8ohm receiver driving 4ohm M&K speakers? posted by Trey on January 07, 1999 at 09:21:32:

I think most manufacturers use the resistors to make the frequency response flat.
Example: The Speaker has to drivers, and unit one is more efficient than unit two. Then you want to put a resistor to unit one, thus the two units play equal loud (very simplified).
But other manufacturers - other techniques...

Alexander

Follow Ups:

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive