Denon AVR-3200 set up question

Posted by Ken Simmons [IP: 208.8.214.47] on May 26, 1999 at 07:54:55
Using Mozilla/4.6 [en] (Win95; U):

In Reply to: Denon AVR-3200 set up question posted by Mike Dopke on May 26, 1999 at 00:21:33:

Assuming you have a STEREO HI-FI VCR, the only thing I can think of is A BUSTED OR MIS-CONNECTED audio output to the receiver.

I suggest you double-check your VCR1 connections from the VCR - it's entirely possible you got the RIGHT CHANNEL "connected elsewhere" or you have a flaky cable.

I remember having a similar problem. Turns out I connected one of the VCR's INPUT jacks to the receiver instead of the OUTPUT jack.

Assuming you followed the User Manual's instructions "to the letter", the above suggestions are all I can think of. To "double-check", try connecting ANOTHER SOURCE (i.e. CD, stereo TV audio) to the VCR1 input and see if the ProLogic mode works. If it does, then "it's a lock" you 1) mis-connected the VCR, 2) you have a bum interconnect or 3) your VCR somehow "got hosed" (re-check the AUDIO settings - make sure it's not outputting LINEAR MONO audio).

Good luck! :)

Ken

Follow Ups:

• Denon AVR-3200 set up question - Mike Dopke 20:30:57 05/26/99 (2)
  • Denon AVR-3200 set up question - ian wehrman 02:30:06 05/27/99 (0)
  • Denon AVR-3200 set up question - Ken Simmons 01:10:22 05/27/99 (0)

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive