Yamaha rxv2095 to control Phase Linear 400

Posted by Ernest [IP: 196.34.250.5] on October 16, 1999 at 08:31:41
Using Mozilla/4.0 (compatible; MSIE 4.01; Windows 98):

In Reply to: Yamaha rxv2095 to control Phase Linear 400 posted by jj on October 16, 1999 at 08:07:17:

The Phase Linear 400 power amp has only a set of RCA connections and is quite straight forward to connect. If you plan to replace the main channels of your RX-V2095, then remove the coupling links from the Yamaha and use a pair of RCA interconnects from the "pre out" to the Phase Linear. Please note that the tone controls only affect the main channels and if you connect the Phase Linear to the rear channels, only the DSP functions will be active.

Regarding the owner's manual, is there any specific reason why you need a manual? There is nothing to control on the Phase Linear. Just remember not to drive the amp past 200W on the meters otherwise you will end up with a pair of damaged speakers! Bob Carver of Sunfire was the designer of this legendary amp.

Follow Ups:

• Yamaha rxv2095 to control Phase Linear 400 - jj 08:00:56 10/17/99 (1)
  • Yamaha rxv2095 to control Phase Linear 400 - Ernest 12:34:50 10/17/99 (0)

Return to the new SMR Forums Menu

Design & HTML © SMR Home Theatre, Images © SMR Home Theatre cannot be reproduced without permission.  The images on this page are digitally watermarked.  New forum messages should be posted into SMR Forums v2 - http://www.smr-forums.com/

	The Web   SMR Archive